If you see that the clones are already starting to root at the bottom of the cubes, you can already start watering them and make sure to drain the solution from the cubes. Keep the rockwool cubes wet during the entire process of cloning which can take about one to two weeks. Do not worry because, on the 2nd day, you will notice that the cuttings will begin to lift their heads. Allow at least one inch of the stem to be in the rockwool cube.ĭuring the first night, it is quite expected that marijuana cuttings will droop. Clone-X is RTFKT’s foray into the digital sphere, creating a genuinely immersive world for its users worldwide. Squeeze the rockwool cube to hug the stem. Using large tweezers gently push the cannabis cutting into the hole. Tweak the marijuana cuttings to release any air bubbles. Once the cuttings have been obtained, immediately dip them in the rooting liquid for 15 to 30 seconds. Then, make the diagonal cut (1/4 inch below a node) on the stem of the plant where you will get the cuttings from. First, trim any shoots or leaves before taking the clones. Take the marijuana cuttings that are about 2.5 to 3.5 inches plus another one inch below the surface. Use the remaining solution (with pH 6.5) until the marijuana clones will root. But before doing so, keep it hydrated with the same strength nutrient solution having a pH of 6.5. Use 2.5 ml of each component per gallon of water if you are using the GH nutrients. The rockwool cubes should be treated overnight in a nutrient solution having a pH of 5.2.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |